AW-BG-1A-16-5x3 for making 3 pcs bead wire rings at the same time.
||Fully-Auto type bead wire winding maching with auto
ejector, stretch roll, rubber extruder, Pre-heating stand, wire guide
& reel stand.
||There are special design and with patent "Auto pressing the
joint position of bead wire".
So the bead wire overlape joint position will be sticked together
properly while push out from winding former and no need to wrap the
cloth on joint position.
||Bead wire building stand (Auto type) drived by AC servo motor. This
is fully automatic process.
Include Auto feeding -->Auto counting the turns -->Auto pushing
out beadwire from former.
||Tension device control by aire cylinder to prevent bead wire loose
and out of guide roller while former stop running for cutting wire.
||From item NO.8~No.15 can be 2 pcs or 3 pcs bead wire rings winding
at the same time. (There is a slitting cutter for separate bead wire
to 2 pcs or 3 pcs of bead wire rings).
||Automatic temperature controller by oil medium is available for
option by extra charge for extruder.
||Special design of motorise bead wire size change device is available
for option by extra charge.
When change the bead wire former, the position of bead wire pressing
device & bead wire feeding device has to be changed. The traditional
design is changed by hand wheel. We have to loosen the fixing bolt
then adjust the hand wheel then fix bolt angain .
It takes about 30 minutes.
We have a new design, the hand wheel changed to gear motor and the
fixing bolt changed to slide bearing. So the size change will be very
easy. It takes about one minute only.